Product Details:
Payment & Shipping Terms:
|
Brand Name: | Bohyar | Drive Mode: | Manual |
---|---|---|---|
Procssing Standard: | ASME B 16.5 | Min Int Clamp Cap: | 1"(25.4mm) |
Shipping Dimensions: | 495x390x165(mm) | Shipping Weight: | 7.7kg |
High Light: | flange facing equipment,flange refacing machine |
High Performance Manual Flange Facing Tool , Flange Facer Long Service Life
The FFT106 manual flange facing tool produced by our company can be used for 1"-6" (25.4mm-152.4mm) valve flange faces. It is the ideal choice of any machining tool inventory. Due to clamping and machining range, it is a very efficient tool for serving or repairing workshop and piping construction companies and vessel manufacturers.
FFT series of manual flange facing tool are the perfect solution to all small diameter facing problems. They are widely used in pipes, valves, flanges and other damage to the end face of the online repair.
■ No external power supply is needed, and the single-person mode can be easily applied for machining.
■ The portable product can be used in a wide range of applications.
■ It can be installed in any direction, widening the applicable scope.
■ The feeding screw can be replaced rapidly, and the machining of waterlines and smooth surfaces can be done at the same time.
■ The rapid-locking center shaft can be aligned accurately to be kept concentric with the flange face.
■ Machining is done in the cold state, and heat or spark will not be produced.
■ Small-diameter flanges can be machined perfectly and easily by one operator at the accuracy and performance similar to lathes.
Model | FFT106 | |||
Min int clamp cap | 1in(25.4mm) | Max int clamp cap | 6in(152mm) | |
Min facing diam | 1in(25.4mm) | Max facing diam | 14in(350mm) | |
Minimum swing diameter | 460mm | Power | Manual | |
Mounting method | Installed vertically or horizontally | |||
Processing standard | ASME B16.5 | |||
Shipping weight | 17lbs(7.7kg) | Shipping dimensions | 495*390*165mm |
■ Measuring the internal diameter of the pipe
■ Consult the manuals.
■ Take out the expansion block, the connecting block according to the serial number
■ Install the expansion block, the connecting block
■ Rotate the wire rod, adjust the position of the knife
■ Loosen screw and feed
■ Cut the inner ring to ensure the level
■ Tighten the swelling part and feed a certain depth
■ Tighten the screw at the tool post
■ Rapidly lock the central shaft with a ratchet wrench, and accurately align it to ensure the concentric operation along with the flange end face.
■ Properly adjust the tool onto the surface to be machined, and set the feeding size.
■ Hold the hand wheel rotating device to machine the flange end face.
■ No maintenance is needed theoretically after operation, but it us recommended to lubricate the product on a regular basis to maximize the performance and service life.
■ Wear protective clothing including safety goggles, hard hat, steel toe shoes, ear plugs (hearing protection), hair restraints and coveralls.
■ Never wear jewelry when operating rotating machinery.
■ Keep the worksite clean. Use a brush to remove chips from the work piece. Do not use your hands or an air hose to remove chips.
■ Support work material for total machine weight.
■ Keep hands away from machine when operating! Adjustments should only be made when the rotation has stopped. Keep hands away from all pinch points
Contact Person: Kaisa
Tel: +8615050158266
Fax: 86-512-66065466