High Precision Manual Flange Facing Tool , 6" Flange Refacing Machine

High Precision Manual Flange Facing Tool , 6" Flange Refacing Machine

Product Introduction

Regardless of the flange thickness, FFT series of manual flange facers can meet your needs. The FFT106 manual flange facing tool is a small-diameter flange end face machining device, and has the lathe-level machining precision and performance. The product can rapidly, accurately and efficiently meet the site needs of online repair, and help to reduce the downtime and costs of transportation and reassembly. It is an ideal choice for any inventory of machining tools.

Features

■ No external power supply is needed, and the single-person mode can be easily applied for machining.

■ The portable product can be used in a wide range of applications.

■ It can be installed in any direction, widening the applicable scope.

■ The feeding screw can be replaced rapidly, and the machining of waterlines and smooth surfaces can be done at the same time.

■ The rapid-locking center shaft can be aligned accurately to be kept concentric with the flange face.

■ Machining is done in the cold state, and heat or spark will not be produced.

■ Small-diameter flanges can be machined perfectly and easily by one operator at the accuracy and performance similar to lathes.

Technical Parameters

Installation & Processing

■ Measuring the internal diameter of the pipe

■ Consult the manuals.

■ Take out the expansion block, the connecting block according to the serial number

■ Install the expansion block, the connecting block

■ Rotate the wire rod, adjust the position of the knife

■ Loosen screw and feed

■ Cut the inner ring to ensure the level

■ Tighten the swelling part and feed a certain depth

■ Tighten the screw at the tool post

Operating Steps

■ Rapidly lock the central shaft with a ratchet wrench, and accurately align it to ensure the concentric operation       along with the flange end face.

■  Properly adjust the tool onto the surface to be machined, and set the feeding size.

■ Hold the hand wheel rotating device to machine the flange end face.

■ No maintenance is needed theoretically after operation, but it us recommended to lubricate the product on a        regular basis to maximize the performance and service life.

Information and feedback

Maintenance Information: Before the machine or any of its accessories is returned for maintenance, please call Bohyar Company. We will give suggestions on transportation and handover of the machine or accessories, and estimate the time and cost of corresponding maintenance.

Feedback: To constantly improve the satisfaction of users with the product quality and service, we will appreciate if you contact us to present any better operation or service methods of the equipment or any suggestion on the optimization of any technical data. We will consider and undertake to validate your precious suggestions, so as to modify or update the product and operation manual for improvement.