ISO CE Proved Gold Pipe Cutting And Beveling Machine For Stainless Steel Carbon Steel

Electric Pipe Beveling Machine

Product Introduction

Inner mounted pipe beveling machines can be tightened to the internal wall of the pipe end, drive the cutter head to rotate through multi-stage planetary reducer and then bevel small-diameter pipes. The applicable inside diameter of pipes for our pipe beveling machine is up to 240 mm (if the pipe to be beveled is larger than this scope, please choose our split frame machines).

Application

Our ID mounted pipe beveling machines are applied in pipeline installation engineering, rush-repair work, heat exchangers, power plant, nuclear power, petroleum, chemical engineering, natural gas, pharmacy, pressure vessels etc.

Features 

■ Portability: Our BPP series are packed with suitcase, which is convenient for carrying and allows you to finish processing outdoors.

■ Quick installation: After being taken out from the suitcase, the machine will be ready only by positioning it at the center of the pipe through the ratchet wrench and equipping it with a suitable cutter. The process will not exceed 3 minutes. The machine will start to work after pressing down the motor button.

■ Safety and reliability: Through multi-stage deceleration by the internal bevel gear of the angle grinder, the planetary reducer and the internal bevel gear of the main shell, the machines can operate under slow rotating speed while keeping large torque, which makes the beveled end smooth and flat and in high quality, and extends the service of the cutter.

Technical Parameters

Product series

*Electric: Rated voltage of 220V, 50/60Hz

Safety Instructions

Safety is our priority when pipe beveling machines are designed, and ergonomics is also taken into consideration to ensure product safety and reliability.

■ Operators should read the safety instructions carefully before operation and properly keep them for reference at any time.

■ Operators should be well aware of the products and fully familiar with the key points of product operations.

■ Please wear suitable working clothes and safety shoes before operation.

■ Before operation, ensure the operators are kept away from any live part such as motors and cables.

■ Operators should be kept away from the rotating cutter head as far as possible for safety when the machine is working.

■ The machines should be used in clean environment and should not be used in messy circumstances; if it is necessary to be used in dusty conditions, please wear masks before operation.

■ For electrical pipe beveling machines, please check whether the voltage of the power supply is correct; for pneumatic pipe beveling machines please check whether air pressure and flow of the air source are correct.

Information and Feedback

Maintenance Information: Before the machine or any of its accessories is returned for maintenance, please call Bohyar Company. We will give suggestions on transportation and handover of the machine or accessories, and estimate the time and cost of corresponding maintenance.

Feedback: To constantly improve the satisfaction of users with the product quality and service, we will appreciate if you contact us to present any better operation or service methods of the equipment or any suggestion on the optimization of any technical data. We will consider and undertake to validate your precious suggestions, so as to modify or update the product and operation manual for improvement.