Low Friction Electric Pipe Beveling Machine Tube Chamfering Machine BPP4E

Low Friction Electric Pipe Beveling Machine Tube Chamfering Machine BPP4E

Product Introduction

Inner mounted pipe beveling machines can be tightened to the internal wall of the pipe end, drive the cutter head to rotate through multi-stage planetary reducer and then bevel small-diameter pipes. The applicable inside diameter of pipes for our pipe beveling machine is up to 240 mm (if the pipe to be beveled is larger than this scope, please choose our split frame machines).

Features 

■ Compact structure and good appearance, high strength aluminum body

■ Lightweight and high-strength aluminum - ensure portability.

■ Interchangeability of components - allows accessories & tool slides to mount to multiple ring sizes

■ Cold machining - no heat affected zones.

■ Precision-manufactured tool slides - ensure absolute rigidity.

■ Quick installation, positioning the machine in the center of the tube and install the appropriate tool to complete the preparation.

■ Well-adapted, you can make the speed adjust depend on the working conditions.

Technical Parameters

Product series

*Electric: Rated voltage of 220V, 50/60Hz

Installation & Processing

■ Measure the inside diameters of the pipe to be processed and choose a suitable machine and expansion block.

■ Select the appropriate block, place it on the bottom of the expansion block to ensure the top surface of the expansion block remain horizontal without any inclination, and rotate the sleeve anticlockwise to tighten the expansion block and, ensure that the machine is firmly fixed in the pipeline.

■ Choose a tool with suitable angle listed in the tool table based on the processing requirements, install it on the cutter head of the machine and tighten the bolts to fix the tools.

■ Rotate the feed hand wheel and extend the feed spindle Loosen screw and feed.

■ Stretch the machine expansion mechanism into the pipe, and reserve sufficient feed space between the tool on the cutter head and the pipe end face.

■ Rotate the expansion sleeve with the ratchet wrench while adjusting the position of the machine to ensure the feed spindle and the center of the pipe is concentric; Tighten nuts on the expansion sleeve with the ratchet wrench after determining the position.

■ Start the motor. Rotate the feed handwheel to make the cutting edge contact with the pipe wall, and then bevel.

Safety Instructions

Safety is our priority when pipe beveling machines are designed, and ergonomics is also taken into consideration to ensure product safety and reliability.

■ Operators should read the safety instructions carefully before operation and properly keep them for reference at any time.

■ Operators should be well aware of the products and fully familiar with the key points of product operations.

■ Please wear suitable working clothes and safety shoes before operation.

■ Before operation, ensure the operators are kept away from any live part such as motors and cables.

■ Operators should be kept away from the rotating cutter head as far as possible for safety when the machine is working.

■ The machines should be used in clean environment and should not be used in messy circumstances; if it is necessary to be used in dusty conditions, please wear masks before operation.

■ For electrical pipe beveling machines, please check whether the voltage of the power supply is correct; for pneumatic pipe beveling machines please check whether air pressure and flow of the air source are correct.