Payment & Shipping Terms:
|Brand Name:||Bohyar||Drive Mode:||Pneumatic|
|Material:||High Strength Aluminum||Item No.:||BPP3P|
|Wall Thickness:||≤15mm||Rated Power:||1.43kw|
pneumatic pipe beveler,
pneumatic beveling tools
Beveling tools of BPP inner mounted pipe beveling machines can bevel different angles under customer requirement. Our tools are made of high-speed steel and applicable to process all types of carbon steel. Therefore, our BPP ID mounted pipe beveling machines are your best choice for processing small-diameter pipes from12.5mm to 240mm ID. up to a wall thickness of 18mm.
BPP series of pipe beveling machines are widely applied in boiler plants, pressure vessels, heat exchangers, power plant, nuclear power, petroleum, chemical engineering, natural gas, pharmacy, pipe prefabrication plant, pipeline installation engineering, rush-repair work, etc.
*Electric: Rated voltage of 220V, 50/60Hz
■ Measure the inside diameters of the pipe to be processed and choose a suitable machine and expansion block.
■ Select the appropriate block, place it on the bottom of the expansion block to ensure the top surface of the expansion block remain horizontal without any inclination, and rotate the sleeve anticlockwise to tighten the expansion block and, ensure that the machine is firmly fixed in the pipeline.
■ Choose a tool with suitable angle listed in the tool table based on the processing requirements, install it on the cutter head of the machine and tighten the bolts to fix the tools.
■ Rotate the feed hand wheel and extend the feed spindle Loosen screw and feed.
■ Stretch the machine expansion mechanism into the pipe, and reserve sufficient feed space between the tool on the cutter head and the pipe end face.
■ Rotate the expansion sleeve with the ratchet wrench while adjusting the position of the machine to ensure the feed spindle and the center of the pipe is concentric; Tighten nuts on the expansion sleeve with the ratchet wrench after determining the position.
■ Start the motor. Rotate the feed handwheel to make the cutting edge contact with the pipe wall, and then bevel.
Safety is our priority when pipe beveling machines are designed, and ergonomics is also taken into consideration to ensure product safety and reliability.
■ Operators should read the safety instructions carefully before operation and properly keep them for reference at any time.
■ Operators should be well aware of the products and fully familiar with the key points of product operations.
■ Please wear suitable working clothes and safety shoes before operation.
■ Before operation, ensure the operators are kept away from any live part such as motors and cables.
■ Operators should be kept away from the rotating cutter head as far as possible for safety when the machine is working.
■ The machines should be used in clean environment and should not be used in messy circumstances; if it is necessary to be used in dusty conditions, please wear masks before operation.
■ For electrical pipe beveling machines, please check whether the voltage of the power supply is correct; for pneumatic pipe beveling machines please check whether air pressure and flow of the air source are correct.
Contact Person: Kaisa